Rockwell-automation AADvance Controller Configuration Guide Manuel d'utilisateur télécharger pdf (Page 198)

100

101



9-12

Document: 553633

ICSTT-RM405f-EN-P

Issue 07

Configuration Guide (AADvance Controller)

Connect Multiple Slave Devices, Full Duplex

You can use a full duplex serial connection to connect multiple Modbus slave devices

to the AADvance controller. To make the physical connection, do the following:

1) Select a suitable cable. We recommend 3-pair, overall shielded cable.

2) Remove the serial port connector from the 9100 processor base unit.

3) Make the connections shown in the illustration. Terminate the twisted pairs with a

120 resistor in series with a 68nF capacitor at the locations shown.

4) Connect the signal ground (not illustrated) from the 0V terminal to each slave

device.

Note: Do not connect the signal ground to the AC safety ground.

5) Insert the connector into the 9100 processor base unit.

1 2 ... 193 194 195 196 197 198 199 200 201 202 203 ... 285 286

Commentaires sur ces manuels

Pas de commentaire

Rockwell-automation AADvance Controller Configuration Guide Manuel d'utilisateur Page 198

Commentaires sur ces manuels

Produits connexes et manuels pour Équipement Rockwell-automation AADvance Controller Configuration Guide