Rockwell-automation GV3000/SE Operator Interface Module (OIM) User Gui Manuel d'utilisateur télécharger pdf (Page 46)

5-6

GV3000/SE Operator Interface Module (OIM) User Guide, Version 2.0

Step 3. Press to clear the screen and continue. The screen shown in figure

5.5 is displayed.

Step 4. Press to start self-tuning. A message and the motor speed during

self-tuning are displayed, as shown in figure 5.6. In the few minutes that

self-tuning takes, you can view other outputs by going to monitor mode.

Note that if you go into monitor mode during self-tuning, you must return to program

mode at the completion of self-tuning to see the following screens. Self-tuning is

complete when the drive stops running.

Figure 5.4 – Attention Screen Displayed After Enabling Self-Tuning

Figure 5.5 – Self-Tuning Enabled Screen

Figure 5.6 – Self-Tuning Active Screen

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 111 112

Pas de commentaire

Rockwell-automation GV3000/SE Operator Interface Module (OIM) User Gui Manuel d'utilisateur Page 46