Rockwell-automation GV3000/SE Operator Interface Module (OIM) User Gui Manuel d'utilisateur télécharger pdf (Page 39)

Basics of Programming the Drive Using the OIM

4-9

Step 3. Select the Memory Functions menu.

Step 4. Select the PROGRAMMING DISABLE (P.051) parameter. If programming is

currently:

•

Disabled: The message ”Do you wish to enter the password to ENABLE

program protection?” is displayed.

•

Enabled: The message “Do you wish to enter the password to DISABLE

program protection?” is displayed.

Step 5. Select YES or NO. Press .

•

YES: Advances you to the PROGRAMMING DISABLE parameter entry

screen, as shown in figure 4.11.

•

NO: Keeps the current setting. You are returned to the Memory Functions

menu.

Step 6. Press to change the value to 26. (You cannot set a different password.)

Step 7. Press . You are returned to the Memory functions menu and the

PROGRAMMING DISABLE setting is changed.

If you select NO or enter the wrong password when you try to change a parameter, the

message “PROGRAM ERROR! PASSWORD PROTECTION IS ENABLED” is

displayed.

4.3 Restoring Factory Default General Parameters

You can restore the factory default values of General (P.---) Parameters. To restore the

factor defaults:

Step 1. Press until the key indicator reads PROGRAM. Make sure you are at

the Main Menu by pressing until GV3000 Main Menu is displayed at

the top of the screen.

Step 2. Select Memory Functions. Press .

Step 3. Select RESTORE DEFAULTS (P.050). Press . The RESTORE

DEFAULTS parameter entry screen is displayed.

Figure 4.11 – PROGRAMMING DISABLE Parameter Entry Screen

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 111 112

Pas de commentaire

Rockwell-automation GV3000/SE Operator Interface Module (OIM) User Gui Manuel d'utilisateur Page 39