Rockwell-automation GV3000/SE Operator Interface Module (OIM) User Gui Manuel d'utilisateur télécharger pdf (Page 17)

Description of the OIM Keypad, Display, and Indicators

2-5

2.2 The Display

OIM screens allow you to program and monitor the drive. Figure 2.2 shows the OIM

display at the Main Menu in program mode.

The display contains three main areas:

•

the normal display area, where the program or monitor mode information is

displayed. See chapter 4 for information on program mode. See chapter 6 for

information on monitor mode.

•

the status indicator area. See section 2.2.1 for more information.

•

the key indicator area. See section 2.2.2 for more information

2.2.1 Drive Status Indicators

The drive status indicators on the right side of the display allow you to quickly check

the status of the drive. In figure 2.2, the Interlock OK and Drive Ready indicators are

on. Drive status indicators are described in table 2.3.

Figure 2.2 – OIM Display in Program Mode with Main Menu Displayed

Table 2.3 – Drive Status Indicators

Indicator State Description

Fault On At least one fault has occurred. See chapter

7 for information on faults.

Off There are no drive faults.

Alarm On At least one alarm has occurred. See

chapter 7 for information on alarms.

Off There are no drive alarms.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 111 112

Pas de commentaire

Rockwell-automation GV3000/SE Operator Interface Module (OIM) User Gui Manuel d'utilisateur Page 17