Rockwell-automation GV3000/SE Operator Interface Module (OIM) User Gui Manuel d'utilisateur télécharger pdf (Page 3)

Contents

ONTENTS

Chapter 1 Introduction to the OIM

1.1 Differences Between the OIM and the Front Panel Keypad/Display ............... 1-1

1.2 Related Publications........................................................................................ 1-2

1.3 Getting Assistance from Reliance Electric....................................................... 1-3

Chapter 2 Description of the OIM Keypad, Display, and Indicators

2.1 The Keypad ..................................................................................................... 2-1

2.2 The Display...................................................................................................... 2-5

2.2.1 Drive Status Indicators .......................................................................... 2-5

2.2.2 Key Indicators ....................................................................................... 2-6

2.2.3 Special Display Characters ................................................................... 2-7

Chapter 3 Installing, Powering, and Adjusting the OIM

3.1 Installing or Replacing the OIM ....................................................................... 3-1

3.1.1 OIM Kit Contents................................................................................... 3-1

3.1.2 Equipment Needed to Install or Replace the OIM................................. 3-2

3.1.3 Installing the OIM .................................................................................. 3-2

3.1.4 Replacing the OIM ................................................................................ 3-4

3.2 Powering Up the OIM ...................................................................................... 3-4

3.3 Adjusting the Screen Contrast......................................................................... 3-5

3.4 Changing the Language Displayed on the OIM............................................... 3-6

3.5 Scaling Speed Units for Your Application........................................................ 3-7

3.5.1 Scaling Speed Units.............................................................................. 3-7

3.5.2 Setting OTHER Speed Units................................................................. 3-8

Chapter 4 Basics of Programming the Drive Using the OIM

4.1 Accessing OIM Menus and Parameters .......................................................... 4-1

4.1.1 Accessing the Menus ............................................................................ 4-1

4.1.2 Using Help in Program Mode ................................................................ 4-2

4.1.3 Accessing the Parameters .................................................................... 4-4

4.1.4 Viewing Parameter Values.................................................................... 4-6

4.1.5 Changing Parameter Values ................................................................. 4-6

4.1.6 Parameter Values that Cannot be Changed ......................................... 4-8

4.2 Using a Password to Protect Programming..................................................... 4-8

4.3 Restoring Factory Default General Parameters .............................................. 4-9

Chapter 5 Using Quick Start to Program the Drive

5.1 Preparing for Quick Start ................................................................................. 5-1

5.2 Using the Quick Start Exit Menu...................................................................... 5-2

5.3 Programming the Drive Using Quick Start....................................................... 5-3

5.4 Self-Tuning Drives Programmed for Vector Regulation .................................. 5-4

5.4.1 Setting Up the OIM for Self-Tuning ....................................................... 5-5

5.4.2 Performing Self-Tuning ......................................................................... 5-5

5.4.3 Exiting Before Self-Tuning is Complete................................................. 5-7

5.4.4 What To Do If a Fault Occurs During Self-Tuning................................. 5-7

5.5 Quick Start Parameter Descriptions ................................................................ 5-8

1 2 3 4 5 6 7 8 ... 111 112

Commentaires sur ces manuels

Pas de commentaire

Rockwell-automation GV3000/SE Operator Interface Module (OIM) User Gui Manuel d'utilisateur Page 3

Commentaires sur ces manuels

Produits connexes et manuels pour Équipement Rockwell-automation GV3000/SE Operator Interface Module (OIM) User Gui