Rockwell-automation 1769-IF4XOF2 Compact 8-Bit Low Resolution Analog I Manuel d'utilisateur télécharger pdf (Page 18)

Publication 1769-UM008A-EN-P - November 2001

2-2 Quick Start for Experienced Users

What You Need To Do

This chapter covers:

• Verify power supply is adequate on page 2-2

• Attach and lock the module. on page 2-2

• Mount the I/O bank. on page 2-3

• Wire the module. on page 2-4

• Configure the module on page 2-5

• Start the system. on page 2-6

• Monitor the module status. on page 2-6

Ensure that your power supply has sufficient current output to

support your system configuration. The modules maximum current

draw is shown below.

a. Check that the bus lever of the module to be installed is in the

unlocked (fully right) position.

b. Use the upper and lower tongue-and-groove slots to secure the

modules together (or to a controller).

c. Move the module back along the tongue-and-groove slots until

the bus connectors line up with each other.

d. Push the bus lever back slightly to clear the positioning tab. Use

your fingers or a small screwdriver.

Step 1:

Verify power supply is adequate

Reference

Chapter 3

(Installation and Wiring)

Module 5V dc 24V dc

1769-IF4XOF2 120 mA 160 mA

TIP

The module cannot be located more than 8 modules

away from the system power supply.

Step 2:

Attach and lock the module.

Reference

Chapter 3

(Installation and Wiring)

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 103 104

Pas de commentaire

Rockwell-automation 1769-IF4XOF2 Compact 8-Bit Low Resolution Analog I Manuel d'utilisateur Page 18