Rockwell-automation 1761-NET-ENIW MicroLogix Ethernet Interface (ENI) Manuel d'utilisateur télécharger pdf (Page 98)

Publication 1761-UM006E-EN-P - August 2005

8-6 Connecting CompactLogix Controllers on Ethernet

used to configure this ENI/ENIW. When you start the ENI/ENIW

Configuration Utility, the following screen appears:

Figure 8.3 ENI/ENIW Configuration Utility ENI IP Addr Screen

For this example, we use 38400 baud on all serial connections. We

also assign IP addresses to all Ethernet products rather than using

BOOTP.

The “ENI IP Addr” tab and the “Message Routing” tab in the

ENI/ENIW Configuration Utility must be modified for the purposes of

this example. The IP address for the ENI/ENIW connected to the

CompactLogix controller (ENI #2) is the only address we need to add

to the ENI #1 Message Routing table. The other two Ethernet devices

are accessed by the computer via the computer’s Ethernet card. Set up

the two ENI #1 tabs as follows:

Figure 8.4 ENI #1 Configuration - ENI IP Addr Screen

IMPORTANT

The ENI series listed on the ENI IP Addr tab

determines which fields are available to modify. If

you attempt to save a higher series configuration to a

lower series ENI, the save will fail. However, a lower

series configuration can be saved to a higher series

ENI.

1 2 ... 93 94 95 96 97 98 99 100 101 102 103 ... 143 144

Pas de commentaire

Rockwell-automation 1761-NET-ENIW MicroLogix Ethernet Interface (ENI) Manuel d'utilisateur Page 98