Rockwell Automation 22-WIM-N4S Manuel d'utilisateur télécharger pdf (Page 20)

2-4 Installing the WIM

9. Establish wireless communication between the WIM and the Pocket

PC or computer. For this procedure, refer to the respective section in

Chapter 3 that corresponds to the drive software tool you are using:

• Using Pocket DriveExplorer for Pocket PC

on page 3-2

• Using DriveExplorer/DriveExplorer Lite on page 3-10

• Using DriveExecutive on page 3-16

When communication is achieved, the WIM status LED will turn

solid blue.

Figure 2.4 Mounting NEMA 4 WIM onto Panel

The drive can remain powered when removing a WIM.

Remove the WIM from the remote-mounted HIM bezel.

➌

➋

➍

➎

➏

0.68 N-m

(6.0 lb.-in.)

Removing the NEMA 1 WIM (22-WIM-N1)

ATTENTION: Risk of injury or equipment damage exists. If the HIM

bezel cable (for a bezel-mounted WIM) is disconnected from Port 2 on

the bottom of the drive, the drive may fault. Determine how the drive

will respond before disconnecting the cable.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 99 100

Pas de commentaire

Rockwell Automation 22-WIM-N4S Manuel d'utilisateur Page 20