Rockwell-automation Liqui-Flo Control Configuration Software Version 6 Manuel d'utilisateur télécharger pdf (Page 73)

Using PC Scope

9-1

CHAPTER 9

Using PC Scope

This section describes how to use the PC Scope.

9.1 About PC Scope

Use PC Scope to plot drive signals. PC Scope displays the plotted values as a trace.

The type of signals you can acquire depends upon the drive you have connected.

With PC Scope, you can:

• acquire traces of up to two signals at a time

• capture a trace and save it as a snapshot, which you can then compare to a newly

acquired trace

• define a trigger for the traces and specify how much data is gathered and

displayed before the trigger condition

• define a data sampling rate and the number of samples to capture for a given

trace

• define a color for each to help you discern traces and trace snapshots

Figure 9.1 shows the PC Scope screen. The screen has its own toolbar and status

window. Table 9.1 explains the PC Scope toolbar buttons.

1 2 ... 68 69 70 71 72 73 74 75 76 77 78 ... 99 100

Pas de commentaire

Rockwell-automation Liqui-Flo Control Configuration Software Version 6 Manuel d'utilisateur Page 73