Rockwell-automation Liqui-Flo Control Configuration Software Version 6 Manuel d'utilisateur télécharger pdf (Page 52)

5-10

Control and Configuration Software V6.1

Step 3. Click Start Profile. The following message is displayed:

“Profile will run the motor alternating between xxx RPM for x.x sec and

xxx RPM for x.x sec. Acceleration time is x.x sec, deceleration time is x.x sec.

Select OK to run the motor using this profile, or Cancel to quit.”

Step 4. Click Ok to start the profile.

The drive will cycle between Speed 1 and Speed 2, staying at each speed for

the amount of time entered for Time 1 and Time 2. You can monitor results in

PC Scope (see chapter 9).

Step 5. Click Stop/Reset to stop the drive and the profile.

Some drive parameters (accel/decel) may be modified automatically in order

to run the profile. These values will be saved prior to being modified by this

function and the original values will be restored when Stop/Reset is selected.

This completes the Custom tuning process.

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 99 100

Pas de commentaire

Rockwell-automation Liqui-Flo Control Configuration Software Version 6 Manuel d'utilisateur Page 52