Rockwell-automation 2707-NP2 MICROVIEW SOFTWARE PROGRAMMING MANUAL Manuel d'utilisateur télécharger pdf (Page 34)

Publication 2707-PM002B-EN-P

4-4 Creating or Editing an Application File

Note: If the same file name currently exists, you are prompted

if you want to overwrite the existing file.

2. Press [Return] to save the application under the file name

entered when the application file was opened.

Or enter a new file name of less than eight characters:

If you were creating a new file, the new file name replaces the

file name entered when the application was opened.

If you are editing an existing file, the original file is unchanged.

The file and all edits made prior to the last save are stored under

the new file name.

3. After saving the file, you can continue editing the application

program.

To save an application before exiting:

1. Exit the software by pressing [F10].

You are prompted save the application under the current file

name or you can enter a new file name.

2. If you enter a new file name, the original file is unchanged and

all edits are stored under the new file name.

After saving the file, you are returned to the DOS prompt.

FILE EXISTS!!! OVERWRITE? (Y or N)

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 133 134

Pas de commentaire

Rockwell-automation 2707-NP2 MICROVIEW SOFTWARE PROGRAMMING MANUAL Manuel d'utilisateur Page 34