Rockwell-automation 1788-EN2DN Ethernet-to-DeviceNet Linking Device Manuel d'utilisateur télécharger pdf (Page 8)

8 Ethernet-to-DeviceNet Linking Device

Rockwell Automation Publication 1788-IN055C-EN-P - September 2011

Optional Software

RSLogix



5000 software, version 13 or later.

Installing and Configuring the Linking Device

Follow these steps to install the linking device (described in the sections that

follow).

WARNING: If you connect or disconnect the communication cable with power

applied to this module or any device on the network, an electrical arc can occur. This

could cause an explosion in hazardous location installations.

If you connect or disconnect wiring while the field-side power is on, an electrical arc

can occur. This could cause an explosion in hazardous location installations. Be sure

that power is removed or the area is nonhazardous before proceeding.

When you change switch settings while field-side power is on, an electrical arc can

occur. This could cause an explosion in hazardous location installations.

Be sure that power is removed or the area is nonhazardous before proceeding.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 55 56

Pas de commentaire

Rockwell-automation 1788-EN2DN Ethernet-to-DeviceNet Linking Device Manuel d'utilisateur Page 8