Rockwell-automation 1788-EN2DN Ethernet-to-DeviceNet Linking Device Manuel d'utilisateur télécharger pdf (Page 23)

Ethernet-to-DeviceNet Linking Device 23

Rockwell Automation Publication 1788-IN055C-EN-P - September 2011

9. Enter the desired MAC address or data rate, then click Apply.

10. Click Close.

11. Restart RSNetworx for DeviceNet software and go online.

IMPORTANT

The linking device will automatically reset if a new MAC ID is entered. If only

the communication rate is changed you must cycle power to the linking

device before the new communication rate will take effect.

When the MAC ID is changed, the linking device’s I/O configuration is cleared.

TIP

If you are using the linking device as a network gateway, you may need to

restart RSNetWorx for DeviceNet software before continuing.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 55 56

Pas de commentaire

Rockwell-automation 1788-EN2DN Ethernet-to-DeviceNet Linking Device Manuel d'utilisateur Page 23