Rockwell-automation 1785-RC Application Relay Interface Installation I Manuel d'utilisateur télécharger pdf (Page 2)

 3/&5HOD\&DUWULGJH

,PSRUWDQW Use of the relay cartridge requires the Series E, revision E

firmware release. If your processors are not already at this

revision level, contact Rockwell Automation Technical

Support to receive this firmware.

Install the Relay Cartridge

1. Turn off power to the I/O chassis and PLC-5 controller.

2. Insert the relay cartridge firmly but gently into the controller (with the

keying pins in the down position) until the cartridge is fully seated in

the controller mating connector.

ATTENTION: Do not insert or remove the relay cartridge

while power is applied to the chassis and/or controller.

Insertion or removal under power can cause memory loss

and processor fault.

Keying pin

1 2 3 4 5 6 7 ... 11 12

Pas de commentaire

Rockwell-automation 1785-RC Application Relay Interface Installation I Manuel d'utilisateur Page 2