Rockwell-automation 842E CM Integrated Motion Encoder on EtherNet/IP Manuel d'utilisateur télécharger pdf (Page 41)

Rockwell Automation Publication 842E-UM002A-EN-P - November 2013 41

Configuring the 842E-CM Encoder Using the Logix Designer Application Chapter 5

b. Set the values in the Message Configuration dialog box as

shown.

NOTE: The Source Element must be a REAL data type, and its default

value is 6000 rps.

c. Click the Communication tab and browse to the encoder tag; in

this case, “encoder” as shown.

The same procedure is required for the following parameters.

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 63 64

Pas de commentaire

Rockwell-automation 842E CM Integrated Motion Encoder on EtherNet/IP Manuel d'utilisateur Page 41