Rockwell-automation 842E CM Integrated Motion Encoder on EtherNet/IP Manuel d'utilisateur télécharger pdf (Page 36)

36 Rockwell Automation Publication 842E-UM002A-EN-P - November 2013

Chapter 5 Configuring the 842E-CM Encoder Using the Logix Designer Application

6. Click the Attribute tab and edit the default values as appropriate for

your application. For this encoder, a coarse update rate from 4…32

ms is supported. If you set the coarse update rate outside that

range, you will receive an error message.

7. Click OK.

Configuring Axis Properties

Follow these steps to configure axis properties.

1. Right-click the axis in the Controller Organizer and choose

Properties.

2. Select the General Category.

3. From the General pull-down menus, change configuration settings

as needed for your application.

4. From the Associated Module >Module pull-down menu, choose

your encoder.

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 63 64

Pas de commentaire

Rockwell-automation 842E CM Integrated Motion Encoder on EtherNet/IP Manuel d'utilisateur Page 36