Rockwell-automation 842D-60131331BXA DeviceNet Encoder User Manual Manuel d'utilisateur télécharger pdf (Page 30)

5-4 Configuring a Scanner to Communicate with the Encoder

Example DeviceNet Network This section provides the steps that are needed to configure a simple

network that includes 1756-DNB/A scanner (Node 10) and an 842D

DeviceNet encoder (Node 03).

Setting Up the Scan List For the scanner to communicate with a product, the scanner must be

configured and the product’s node number must be added to its scan

list.

1. Go online with RSNetWorx for DeviceNet. Refer to the “Going

Online” section in Chapter 4.

2. Select Network > Single Browse Path. The devices on the

network are displayed in the configuration view.

Figure 5.1 Configuration View (Graph)

3. Right-click the DeviceNet scanner (node 10 in Figure 5.1) and

select Properties. The Scanner Module dialog box appears.

Important: If your scanner is an unrecognized device, you must

create an EDS file for it and then configure it. Click Help or refer to

your scanner documentation if you need more information. Configure

the scanner using the General and Module tabs.

4. Click the Scanlist tab. A message box prompts you to upload.

5. Click Upload. Data is uploaded from the scanner, and then the

Scanlist page appears.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 57 58

Pas de commentaire

Rockwell-automation 842D-60131331BXA DeviceNet Encoder User Manual Manuel d'utilisateur Page 30