Rockwell-automation 2707-NP DTAM Programming Software Manuel d'utilisateur télécharger pdf (Page 41)

Chapter 4

Creating or Editing an Application File

4–5

2. Press [Return] to save the application under the file name entered when

the application file was opened.

Or enter a new file name:

If you were creating a new file, the new file name replaces the file

name entered when the application was opened.

If you are editing an existing file, the original file is unchanged.

The file and all edits made prior to the last save are stored under the

new file name.

3. After saving the file, you can continue with your editing of the application

To save an application before exiting:

1. Exit the software by pressing [F10].

You are prompted save the application under the current file name or you

can enter a new file name.

2. If you enter a new file name, the original file is unchanged. All edits are

stored under the new file name.

After saving the file, you are returned to a DOS prompt.

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 183 184

Pas de commentaire

Rockwell-automation 2707-NP DTAM Programming Software Manuel d'utilisateur Page 41