Rockwell-automation 2707-NP DTAM Programming Software Manuel d'utilisateur télécharger pdf (Page 171)

A–B

Appendix

D-1

Data Formats

The data selected for a controller address must reflect the same format as the

data actually stored in that address. This is the only way you can ensure that

correct, consistent information is displayed.

For example, selecting 16 Bit Signed Integer format for address N7:10

displays data one way and selecting 16 Bit BCD format for the same address

displays data another way. It is important to understand each data format and

its characteristics.

The following table illustrates all data formats supported by PLC and SLC

controllers including the point types and ranges applicable to each format,

and whether the scaling may be used.

Data Format PLC Register Range Scaling User Input Range

Bit 0,1 No 0, 1, Y, N

16 Bit Signed Integer -32,768 to +32,767 Yes -32,768 to +32,767

16 Bit Unsigned Integer 0 to +65,535 Yes -32,768 to +32,767

16 Bit BCD 0 to 9999 Yes

-32,768 to +32,767 ➀

16 Bit Hex 0 to FFFF No NA

32 Bit Unsigned Integer 0 to +4,294,967,295 No 0 to +4,294,967,295

32 Bit BCD 0 to +99,999,999 No 0 to +99,999,999

32 Bit Hex 0 to FFFFFFFF No NA

ASCII 20 Characters, Max No NA

Floating Point ➁ ±1.175495E

-38

±3.402823E

+38

Yes

±1.175495E

-38

±3.402823E

+38

➀ 16 Bit BCD is 0-9999 on an SLC, but data can be scaled to -32,768 to +32, 768.

➁ Not available on SLC controllers.

Data Formats

1 2 ... 166 167 168 169 170 171 172 173 174 175 176 ... 183 184

Pas de commentaire

Rockwell-automation 2707-NP DTAM Programming Software Manuel d'utilisateur Page 171