Rockwell-automation 1785-ENET PLC-5 Ethernet Interface Module Installa Manuel d'utilisateur télécharger pdf (Page 7)

PLC-5 Ethernet Interface Module 7

Publication 1785-IN019B-EN-P - January 2007

Follow these directions to see or activate the new configuration and status features:

1. Open or create a project in RSLogix 5 software, version 7.1 or later.

2. Click the Channel Configuration menu.

You see the Edit Channel Properties screen.

3. Click the Channel 3A tab.

4. Select Ethernet/C from the Channel Type pull-down menu.

BOOTP, DHCP, or Static Entry of IP Address

As shown in the following dialog, you can select between a static or dynamic network

configuration.

• The default is Dynamic Network Configuration Type and

Use BOOTP to obtain network configuration.

• If you choose a dynamic network configuration, you can change the default BOOTP

to DHCP.

• If you choose a static network configuration type, you must enter the IP address.

Similarly, if you have a dynamic network configuration, DHCP or BOOTP assigns the

controller’s hostname. With a static configuration, you assign the hostname.

1 2 3 4 5 6 7 8 9 10 11 12 ... 47 48

Pas de commentaire

Rockwell-automation 1785-ENET PLC-5 Ethernet Interface Module Installa Manuel d'utilisateur Page 7