Rockwell-automation 1785-ENET PLC-5 Ethernet Interface Module Installa Manuel d'utilisateur télécharger pdf (Page 17)

PLC-5 Ethernet Interface Module 17

Publication 1785-IN019B-EN-P - January 2007

3. Install the combination into the chassis.

Attach the Connector Header to the Controller

With grounding wrist strap attached to your wrist, follow these steps:

1. Locate the controller’s connector header port.

2. Push the exposed pins into the holes on the controller.

3. Attach the module to the end of the connector header.

IMPORTANT

If your power supply is already installed in the chassis, be sure the power

supply is OFF before you install the module. If you install the module with

power ON, you will damage the module.

IMPORTANT

Make certain you carefully align the pins and holes together before you press

the connector header into the controller. Improper alignment will bend the

connector header pins.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 47 48

Pas de commentaire

Rockwell-automation 1785-ENET PLC-5 Ethernet Interface Module Installa Manuel d'utilisateur Page 17