Rockwell-automation 1746-NO8V SLC 500 8-Point Analog Output Module/ Us Manuel d'utilisateur télécharger pdf (Page 20)

Publication 1746-UM026A-EN-P - September 2003

2-12 Installation and Wiring

A system may malfunction due to a change in its operating

environment. After installing and wiring your module, check system

operation. See your controller’s User Manual for more information.

Labeling and Re-Installing

the Terminal Block (if it is

removed)

The supplied terminal cover has a write-on label. Using this label

helps ensure that the terminal block is installed on the correct module.

Once you have wired your module and properly labeled the terminal

cover, install the terminal block on your module:

1. Align the terminal block with the receptacle.

2. Insert the terminal block and press firmly at the top and bottom

until it is properly seated.

3. Screw in the two retaining screws on the top and bottom of the

terminal block. Maximum torque is 0.7 to 0.9 Nm (6 to 8 in-lbs.).

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 73 74

Pas de commentaire

Rockwell-automation 1746-NO8V SLC 500 8-Point Analog Output Module/ Us Manuel d'utilisateur Page 20