Rockwell-automation WebPak CS Software Version 1.0 Manuel d'utilisateur télécharger pdf (Page 42)

7-2

WebPakCS Software V1.0

You can also access other WebPakCS software functions while the Drive Control

window is on the screen. The Drive Control window remains open until you close the

window (by selecting the Close button) or exit the WebPakCS software.

The following sections describe how to use the Drive Control window to control a

drive’s functions.

Important: If a running drive that is being controlled by the WebPakCS software loses

communication with the software, a serial fault occurs and the drive stops.

If the running drive is being controlled by its front-panel and

communication with the software is lost, the message “Disconnected”

appears in the main window status bar.

7.2 Selecting the Control Source

You can select one of the following as the control source for the drive:

• Local

• Terminal Strip

•Serial

•Network

Figure 7.1 – Drive Control Window

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 65 66

Pas de commentaire

Rockwell-automation WebPak CS Software Version 1.0 Manuel d'utilisateur Page 42