Rockwell-automation DC3E Non-Regenerative DC Drive User Guide 1/4 - 2 Manuel d'utilisateur télécharger pdf (Page 60)

52 Calibration

MAX SPD

The MAX SPD setting determines the motor speed when

the speed adjust potentiometer or external reference signal

is set for maximum speed. It is factory set for maximum

rated motor speed.

To calibrate MAX SPD:

1. Set the MAX SPD trimpot full CCW.

2. Turn the speed adjust potentiometer full CW or set the

external reference signal for maximum speed.

3. Adjust the MAX SPD trimpot until the desired

maximum motor speed is reached.

IMPORTANT: Check the MIN SPD and MAX SPD

settings after recalibrating to verify that the motor runs at

the desired minimum and maximum speeds.

IMPORTANT: If operation requires switching between

AUTO and MANUAL modes, the user should verify

calibration for both modes if required.

250-0287-rev2.qxd 3/12/01 10:27 AM Page 52

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 91 92

Pas de commentaire

Rockwell-automation DC3E Non-Regenerative DC Drive User Guide 1/4 - 2 Manuel d'utilisateur Page 60