Rockwell-automation DC3E Non-Regenerative DC Drive User Guide 1/4 - 2 Manuel d'utilisateur télécharger pdf (Page 37)

29Installation

Power input

Connect the AC line power leads to terminals L1 and L2 as

shown in Figure 8 (page 31). Ensure that earth ground is

connected to the green screw inside the case.

Field output

ATTENTION: Do not make any connections to F1 and

F2 when using a permanent magnet motor.The field

output is for shunt wound motors only. See Table 3 for

field output connections.



Table 3. Field Output Connections

Line Voltage Approximate Connect Motor Terminal

(VAC) Field Voltage (VDC) Field To Numbers

115 50 F1 and L1 4 and 1

115 100 F1 and F2 4 and 5

230 100 F1 and L1 4 and 1

230 200 F1 and F2 4 and 5

250-0287-rev2.qxd 3/12/01 10:27 AM Page 29

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 91 92

Pas de commentaire

Rockwell-automation DC3E Non-Regenerative DC Drive User Guide 1/4 - 2 Manuel d'utilisateur Page 37