Rockwell-automation AutoMax ControlNet Communication Interface Module Manuel d'utilisateur télécharger pdf (Page 77)

AutoMax ControlNet Module Page 77

Publication number DSMBCN-UM001B-EN-P February 2003

6. Select Device > Scanlist Configuration. Notice that the status

columns are not displayed.

7. Double-click a connection. On the Connection Properties, note that

three dashes are shown in the Status address field.

8. In the Status address field, specify the desired status offset and click

OK.

9. Repeat steps 7 and 8 for each connection.

10. Select File > Save.

11. Close the Scanlist Configuration Tool.

12. Select Device > Scanlist Configuration again. Notice that the status

columns are now displayed.

13. Verify that the status addresses displayed in the Status address

column are correct.

Tip: If any status offset values are displayed incorrectly, double-click a

connection and enter the correct value.

14. Select File > Save.

15. Select Device > Download to Device.

1 2 ... 72 73 74 75 76 77 78 79 80

Pas de commentaire

Rockwell-automation AutoMax ControlNet Communication Interface Module Manuel d'utilisateur Page 77