Rockwell-automation 22-COMM-C ControlNet Adapter Manuel d'utilisateur télécharger pdf (Page 38)

4-4 Configuring the I/O

6. Click Finish>>. The bridge is now configured for the ControlNet

network. It appears in the I/O Configuration folder. In our example, a

1756-CNBR/D bridge appears under the I/O Configuration folder

(Figure 4.5

) with its assigned name.

Figure 4.5 RSLogix 5000: I/O Configuration Folder

Adding the Adapter and Drive to the I/O Configuration

To transmit data between the bridge and the adapter, you must add the

22-COMM-C adapter as a child device to the parent bridge.

1. In the project tree, right-click on the bridge and select New Module

to display the Select Module Type screen (Figure 4.6

). For this

example, right-click on the 1756-CNBR/D bridge.

Figure 4.6 Select Module Type Screen

2. Select CONTROLNET-MODULE (Figure 4.6) to configure the

22-COMM-C adapter, and then click OK. The Module Properties

screen (Figure 4.7

) appears.

Electronic

Keying

Compatible Module. The “Compatible Module” setting for Electronic

Keying ensures that the physical module is consistent with the software

configuration before the controller and bridge make a connection.

Therefore, ensure that you have set the correct revision in this screen.

Refer to the online help if the controller and bridge have problems

making a connection and you want to change this setting.

Box Setting

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 163 164

Pas de commentaire

Rockwell-automation 22-COMM-C ControlNet Adapter Manuel d'utilisateur Page 38