Rockwell-automation 20P PowerFlex DC Drive - Frame C Transient Noise F Manuel d'utilisateur télécharger pdf (Page 3)

PowerFlex® DC Drive - Frame C Transient Noise Filter Circuit Board 3

Step 2: Remove the

Protective Covers

1. Disconnect the DPI cable from the HIM assembly (if present).

2. Loosen, but do not remove, the screws that secure the bottom cover to

the drive, then slide the cover down and off the drive chassis.

3. Loosen, but do not remove, the screws that secure the top cover to the

drive, then slide the cover up and off the drive chassis.

Important: The HIM assembly is connected via a cable to the Control

board and therefore will not pull free from the drive until

disconnected. See step 4 below for instructions.

STS

PORT

MOD

NET A

NET B

Disconnect

DPI cable

=

Tightening torque:

1.5 N-m (13.3 lb.-in.)

STS

PORT

MOD

NET A

NET B

FU1 FV1

U

V

C

D

W

Tightening torque:

1.5 N-m (13.3 lb.-in.)

1 2 3 4 5 6 7 8 9 10

Commentaires sur ces manuels

Pas de commentaire