Rockwell-automation 1792-OB4E INSTL.INST ARMORBLOCK 4 OUTPUT Manuel d'utilisateur télécharger pdf (Page 26)

ArmorBlock 4 Output Module26

Publication 1792-5.4 – October 1996

Reset Faults

There are various ways to reset faults on an ArmorBlock module.

• cycle power to the module by disconnecting, then reconnecting the

DeviceNet connector

• use the Reset Faulted I/O feature on the parameter screen

• use the explicit message program control feature

• disconnect, then reconnect output power connector

ATTENTION: If you reset a fault by removing and

replacing the output power connector, outputs

(including the faulted output) will be on when power

is reconnected.

Reset Faults Online Using the Parameter Screen

To reset faults online, return to the network screen and proceed as

follows:

1.Click on the faulted device.

2.Then click on the Configure

Device button.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 35 36

Pas de commentaire

Rockwell-automation 1792-OB4E INSTL.INST ARMORBLOCK 4 OUTPUT Manuel d'utilisateur Page 26