Rockwell-automation 1788-CN2DN ControlNet-to-DeviceNet Linking Device Manuel d'utilisateur télécharger pdf (Page 10)

10 ControlNet-to-DeviceNet Linking Device

Publication

1788-IN052D-EN-P - February 2007

Mount the CN2DN Device on a DIN Rail

Complete the following steps to mount the CN2DN device on a DIN

rail.

1. Align the CN2DN device over the DIN rail.

2. Press the CN2DN device onto the DIN rail until the DIN rail

latches lock the linking device in place.

ATTENTION

This product is grounded through the DIN rail to chassis ground. Use

zinc plated yellow-chromate steel DIN rail to assure proper grounding.

The use of other DIN rail materials (for example, aluminum and

plastic) that can corrode, oxidize, or are poor conductors, can result in

improper or intermittent grounding. Secure DIN rail to mounting

surface approximately every 200 mm (7.87 in.) and use end-anchors

appropriately.

IMPORTANT

The DIN rail must be properly grounded. See publication Industrial

Automation Wiring and Grounding Guidelines, publication 1770-4.1

for more information about DIN rail grounding.

Press Forward

and Down

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 51 52

Pas de commentaire

Rockwell-automation 1788-CN2DN ControlNet-to-DeviceNet Linking Device Manuel d'utilisateur Page 10