Rockwell-automation 1784-KT2/C INST.DATA COMM.INTERFACE MOD. Manuel d'utilisateur télécharger pdf (Page 19)

Communication Interface Module

Cat. No. 1784-KT2/C

Installation Data

When the prompt appears, type:

c:\kt2diag [ENTER)

Important: The diagnostic program adds new test results to results

already existing in the output file. If you want to delete test results already

existing in the output file, wait for the prompt to appear and type:

del

kt2out.txt [ENTER]

Do this before you proceed to step 3.

3. When the prompt appears, type:

kt2diag

[ENTER]

You see the following message:

WARNING: Serious damage will occur if 1784–KT2 is

connected to a network. Press any key to acknowledge:

Make sure your 1784–KT2 is not connected to your network

and press any key to continue.

4. Again you are asked if you want to continue. If you have followed

the precautions to guard against network damage explained earlier in

this section, type y. If you have not yet read this information, type n

to exit the diagnostic program. You must read this information before

going any further.

5. An Allen-Bradley copyright message appears on your screen. Press

any key to continue.

The Allen-Bradley 1784–KT2 Diagnostic Program menu appears on your

screen. You are now ready to run the diagnostic program.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 31 32

Pas de commentaire

Rockwell-automation 1784-KT2/C INST.DATA COMM.INTERFACE MOD. Manuel d'utilisateur Page 19