Rockwell-automation 1769-OF8V Compact Analog Output Module Manuel d'utilisateur télécharger pdf (Page 4)

4 Compact 1769-OF8V Analog Output Module

Publication 1769-IN066D-EN-P - June 2010

System Assembly

The module can be attached to the controller or an adjacent I/O module before or after

mounting. For mounting instructions, see “Panel Mounting” on page 6, or “DIN Rail

Mounting” on page 7. To work with a system that is already mounted, see “Replacing a Single

Module within a System” on page 7.

The following procedure shows you how to assemble the Compact I/O system.

1. Disconnect power.

2. Check that the bus lever of the module to be installed is in the unlocked (fully right)

position.

3. Use the upper and lower tongue-and-groove slots (1) to secure the modules together

(or to a controller).

4. Move the module back along the tongue-and-groove slots until the bus connectors (2)

line up with each other.

5. Push the bus lever back slightly to clear the positioning tab (3). Use your fingers or a

small screwdriver.

1 2 3 4 5 6 7 8 9 ... 31 32

Pas de commentaire

Rockwell-automation 1769-OF8V Compact Analog Output Module Manuel d'utilisateur Page 4