Rockwell-automation 1769-ADN DeviceNet Modules Installation Instructio Manuel d'utilisateur télécharger pdf (Page 18)

18 Rockwell Automation Publication DNET-IN001B-EN-P - January 2012

Chapter 1 Install a 1756 DeviceNet Communication Module

Download the Add-on

Profile

If you are using a later firmware revision for the communication module than

recognized in the most current version of RSLogix 5000 software, you may need

to download the Add-on Profile (AOP) for the communication module so it can

be recognized in the Controller Organizer.

1. Locate the module AOP at http://www.rockwellautomation.com/

support/controlflash/LogixProfiler.

2. Click the file to download it.

3. Enter your RSLogix 5000 software serial number and click Qualify for

Update.

4. Download and extract the zipped files to a temporary directory.

5. Shut down any instances of RSLogix 5000 software that are currently

running.

6. In the temporary directory, double-click the MPSetup.exe file and follow

the onscreen instructions to install the AOP.

Connect to the Module

via the USB Port

The module has a USB device port that uses a series B receptacle. Connecting to

the module via the USB port requires these steps:

1. Set Up the Hardware

2. Configure the Module via the USB Port

3. Load Firmware through a USB Port

IMPORTANT

You need a Rockwell Automation MySupport account to

download the AOP. If you do not have one, follow the steps on the

MySupport website to obtain an account.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 67 68

Pas de commentaire

Rockwell-automation 1769-ADN DeviceNet Modules Installation Instructio Manuel d'utilisateur Page 18