Rockwell-automation 1760 Pico GFX-70 Controllers Quick Start Manuel d'utilisateur télécharger pdf (Page 53)

Publication 1760-QS002A-EN-P - April 2004

Lesson 5 7-11

We must also connect the PC to the master that is always represented by the

device shown on the far left (see following figure). For this we require the

1760-CBL-PC02 PC connection cable.

Three stations connected via Pico-Link.

The figure above shows the Pico-Link configuration consisting of three

stations (1), two Pico-Link connection cables 1760-CBL-INT01 (2) and two

bus terminating resistors 1760-TERM1 (3).

Before changing to Communication View, check whether the correct COM

interface is set on your PC. Choose Communication, Interface to determine

which interface is selected and, if necessary, select another one.

We are now read. We then select Communication View using the appropriate

button in the Toolbox.

If the change to Communication View is excessively long and an error message

is output, check/change the selected interface.

Choose Communication, Online to restart the connection establishment.

Once the Communication View has been called up, we must then configure

the Pico-Link.

1 2 ... 48 49 50 51 52 53 54 55 56 57 58

Pas de commentaire

Rockwell-automation 1760 Pico GFX-70 Controllers Quick Start Manuel d'utilisateur Page 53