Rockwell-automation 1751 SynchLink 4-Port Splitter Block Installation Manuel d'utilisateur télécharger pdf (Page 4)

4 SynchLink 4-port Splitter Block

Publication 1751-IN002A-EN-P - March 2001

Prevent Electrostatic Discharge

Installing the 4-port Splitter Block

To install the 4-port splitter block:

1. Position the splitter block on a 35 x 7.5mm DIN rail (Allen-Bradley catalog

number 199-DR1) at a 30° angle.

ATTENTION

Electrostatic discharge can damage integrated circuits or

semiconductors if you touch backplane connector pins.

Follow these guidelines when you handle the splitter block:

• Touch a grounded object to discharge static potential.

• Wear an approved wrist-strap grounding device.

• Do not touch the backplane connector or connector pins.

• Do not touch circuit components inside the splitter block.

• If available, use a static-safe work station.

• When not in use, keep the splitter block in its static-shield

box.

31203a-M

1 2 3 4 5 6 7 8 9 ... 15 16

Pas de commentaire

Rockwell-automation 1751 SynchLink 4-Port Splitter Block Installation Manuel d'utilisateur Page 4