Rockwell Automation 1785 PLC-5 Spécifications télécharger pdf (Page 20)

20 PLC-5 Ethernet Interface Module

Publication 1785-IN019B-EN-P - January 2007

4. Lower the locking bar into place.

Configure the Module for Ethernet Communication

Before configuring channel 3A for Ethernet communication, be sure to:

• know the Ethernet hardware address.

• assign an IP address to the module.

Because the module uses the TCP/IP protocol, each Ethernet hardware address on the

network requires a unique IP address.

The IP address is software-configurable using either the BOOTP protocol or your

programming software package.

Contact your network administrator for a unique IP address to assign to your module.

Configure Channel 3A

Once you obtain the IP address that you will assign to the module, you must configure

channel 3A so your network recognizes the module.

If the module is connected to You must assign

an Ethernet PLC-5 controller two IP addresses:

• one for the controller.

• one for the module.

an Enhanced PLC-5 controller one (1) IP address for the module.

a ControlNet PLC-5 controller one (1) IP address for the module.

20617

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 47 48

Pas de commentaire

Rockwell Automation 1785 PLC-5 Spécifications Page 20