Rockwell-automation SA3100 Distributed Power System Drv Config,Program Manuel d'utilisateur télécharger pdf (Page 48)

3-10

SA3100 Drive Configuration and Programming

map is shown in table 3.7.

Table 3.7 – Register 11/23 - Flex I/O Module 2 Faults

Bit Name Description

0 Module 2 Not Plugged In Set if no device is detected at Module 2 port.

1 Module 2 Communication Error Set if there is a serial communication error with Module 2.

2 Module 2 Bad ID Set if a non-supported module ID is received from Module 2 or if

the module ID received does not match the configured ID.

8 Channel 0 - Open Output/

Underrange Input

Bits 8 to 15 are set if there is an open output (4 - 20 mA current

output only) or an under range input (4 - 20 mA current input

only).

If a digital input is installed for Module 2 these bits are not used.

9 Channel 1 - Open Output/

Underrange Input

10 Channel 2 - Open Output/

Underrange Input

11 Channel 3 - Open Output/

Underrange Input

12 Channel 4 - Open Output/

Underrange Input

13 Channel 5 - Open Output/

Underrange Input

14 Channel 6 - Open Output/

Underrange Input

15 Channel 7 - Open Output/

Underrange Input

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 161 162

Pas de commentaire

Rockwell-automation SA3100 Distributed Power System Drv Config,Program Manuel d'utilisateur Page 48