Rockwell-automation FactoryTalk Metrics User Guide Manuel d'utilisateur télécharger pdf (Page 153)

Automated Configuration Chapter 4

9. Change the existing program file to ensure that the data points

in the UDT that you want to use in the FactoryTalk Metrics

application contain accurate and timely data.

In general, the type of instruction that you will add to the

program depends on the destination data type:

For this data

type:

Used in the UDT by:

Use these instructions:

Integer

Part Counts

Move (MOV)

Boolean Event Triggers A combination of Examine If

Open (XIO) and Output

Energize (OTE)

String Part ID, Flex_String Copy File (COP)

In the Length box of the

COP instruction, specify the

Source_Tag.LEN value.

TIP

For information about adding instructions to your program file,

refer to the RSLogix documentation.

10. On the Communications menu, click Download.

The Download dialog box appears.

11. Click Download.

When the program is loaded to the controller, you can run the

program file.

The following message appears:

12. Click Yes.

13. Repeat the steps for each controller program that will be used

by FactoryTalk Metrics.

Rockwell Automation Publication PLTMT-UM001M-EN-P-June 2014 153

1 2 ... 148 149 150 151 152 153 154 155 156 157 158 ... 271 272

Pas de commentaire

Rockwell-automation FactoryTalk Metrics User Guide Manuel d'utilisateur Page 153