Rockwell-automation AutoMax Prog Exec V4.2 and Dist. Power System Driv Manuel d'utilisateur télécharger pdf (Page 11)

4Ć1

 



NOTE:

""

  

 !"

 

   

 "

"



Use the following procedure to install the Executive software

(M/N 57C605, 57C606, 57C607). This procedure will install the

Executive files and automatically create a Windows program folder

containing the AutoMaxĆrelated icons.

During the installation procedure, the following subdirectories will be

created on the hard disk if they do not already exist:

<DRV>:\<RPE>\<AMX4>\TEMP

<DRV>:\AMXWORK

Step 1. To begin installing the Executive software, insert the disk

labeled 1" in floppy drive A: or B:.

Click Start, then click Run, and then type:

ą<DRV>:\INSTALL.EXE

where:

ą<DRV> is the floppy drive in which you have placed

ąthe disk.

Click OK" to begin the install procedure.

Before installing any files, the install program will perform

a setup operation, and then display messages describing

the type of installation (Single User or Upgrade Single

User) and the amount of hard disk space required for the

Executive software.

If you are installing the upgrade software (M/N 57C606),

you will be prompted that the install procedure requires a

previously installed copy on the hard drive.

Step 2. You will be prompted for the drive and subdirectory in

which to install the software. The defaults are as follows:

ą<DRV>:\<RPE>\<AMX4>

where:

ą<DRV> is the hard drive where Windows is installed

ą<RPE> is the ReSource subdirectory

ą<AMX4> is the AutoMax V4.x subdirectory

You can make changes to any of the above parameters.

<DRV>:\AMXWORK will be the default working drive and

subdirectory. If you need to change the default, you must

do so at the Setup menu in the Executive software.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 27 28

Commentaires sur ces manuels

Pas de commentaire

Rockwell-automation AutoMax Prog Exec V4.2 and Dist. Power System Driv Manuel d'utilisateur Page 11

Commentaires sur ces manuels

Produits connexes et manuels pour Équipement Rockwell-automation AutoMax Prog Exec V4.2 and Dist. Power System Driv