Rockwell-automation AADvance Controller System Build Manuel d'utilisateur télécharger pdf (Page 88)

4-8

Document: 553632

(ICSTT-RM448_EN_P) Issue: 08:

System Build Manual (AADvance Controller)

Ready GREEN

Run AMBER

Channel 1 – 8 Off

6. Press the Fault Reset button on the processor module and the Run indication goes GREEN.

7. The module will now be on-line with the following status indications:

Healthy GREEN

Ready GREEN

Run GREEN

Channel 1 – 8) Dependent on channel status

8. If the module fails to educate and go on-line replace the module.

Table 11:

Table 11: Table 11:

Table 11: Second or third Module of a Group Installation Procedure

Second or third Module of a Group Installation ProcedureSecond or third Module of a Group Installation Procedure

Second or third Module of a Group Installation Procedure

Step Task

1. This procedure applies to a second or third module of a redundant group.

2 Install the Input/Output Module and turn the locking screw to the lock position.

3. The input module will provide the following status indications:

Healthy GREEN

Ready RED

Run RED

Channel 1 – 8 Off

4. The input module will enter its start up sequence during which the module will educate.

Wait for approximately 3 seconds.

5. The module will now provide the following status indications:

Healthy GREEN

Ready GREEN

Run AMBER

Channel 1 – 8 Off

6. Press the Fault Reset button on the processor module and the Run indication goes GREEN.

7. The module will now be on-line with the following status indications:

Healthy GREEN

Ready GREEN

Run GREEN

Channel 1 – 8) Dependent on channel status

1 2 ... 83 84 85 86 87 88 89 90 91 92 93 ... 129 130

Pas de commentaire

Rockwell-automation AADvance Controller System Build Manuel d'utilisateur Page 88