Rockwell-automation 6181F_P Series E Integrated Display Computers Inst Manuel d'utilisateur télécharger pdf (Page 13)

Industrial Integrated Display Computers 13

Rockwell Automation Publication 6181P-IN010F-EN-P - July 2013

Install the Computer

The computers support the following mounting options:

• Panel mount

• Wall mount (for non-display computers)

Panel Mounting Guidelines

Observe these guidelines when installing the computer in a panel:

• Remove all electrical power from the panel before making the cutout.

• Confirm that there is adequate space behind the panel. For specific information, refer to

Mounting Clearances

on page 8.

• Cut supporting panels to specifications before installation. Take precautions so metal

cuttings do not enter components already installed in panel.

Supporting panels must be at least 14 gauge for proper sealing against water and dust,

and to provide proper support. The mounting hardware supplied accommodates panel

thickness 1.5…5.5 mm (0.06…0.25 in.).

• Make sure the area around the panel cutout is clear.

Panel Cutout Dimensions

The computers must be mounted to meet the panel cutout dimensions specified below.

Included with the computer is 6181P and 6181X Industrial Computers Cutout Template,

publication 6181P-DS002

, with a cutout template for each display computer model.

ATTENTION: Failure to follow these guidelines can result in personal injury or damage to the panel

components.

Computer Model Cutout Dimensions (H x W), approx

1200P 254.0 x 324.0 mm (10.0 x 12.76 in.)

1500P 285.0 x 386.6 mm (11.24 x 15.22 in.)

1700P 329.5 x 424.0 mm (12.97 x 16.69 in.)

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 23 24

Pas de commentaire

Rockwell-automation 6181F_P Series E Integrated Display Computers Inst Manuel d'utilisateur Page 13