Rockwell-automation 6155F-NPXPDC Compact Non-display Computers Manuel d'utilisateur télécharger pdf (Page 7)

Compact Industrial Non-display Computers 7

Rockwell Automation Publication 6155R-IN002E-EN-P - July 2013

Required Tools

These tools are required for computer installation:

• #2 Phillips screwdriver

• Drill motor and drill bit

• Antistatic wrist strap (recommended)

Mounting Clearances

Review the computer dimensions to make sure you allow adequate clearance around the

computer for ventilation and cable connections.

When mounted in an enclosure or high temperature area, the ambient temperature around the

computer must not exceed the operating temperature range.

Use this clearance For

25 mm (1 in.) Sides of computer

51 mm (2 in.) Top of computer

13 mm (0.5 in.)

(1)

(1) This clearance is not required when provided mounting hardware is used.

Bottom of computer

None Rear of computer

Adequate clearance for any cables used that extend beyond the handle. Front of computer

1 2 3 4 5 6 7 8 9 10 11 12 ... 19 20

Pas de commentaire

Rockwell-automation 6155F-NPXPDC Compact Non-display Computers Manuel d'utilisateur Page 7