Rockwell-automation 57RF RFID ICODE Handheld Interface User Manual Manuel d'utilisateur télécharger pdf (Page 12)

12 Rockwell Automation Publication 57RF-UM001A-EN-P - September 2011

Chapter 2

ii. Plug one end of the detachable AC cord into the power supply and

the other end into a power outlet as shown below.

Figure 4 - Power Supply Cord

iii. Remove the rubber cover from the RS-232 connector on the bottom

of the RFID ICODE handheld interface.

iv. Place the RFID ICODE handheld interface in the charging cradle as

shown below. The Charge LED should turn on, indicating that the

batteries are charging.

Figure 5 - Interface into Charging Cradle

2. The Charge LED will blink green when the RFID ICODE handheld

interface is fully charged. Unplug the unit or remove it from the charging

cradle.

3. Press and hold the On/Off switch for one second.

The unit should turn on and begin displaying the boot-up process. After

approximately 15 seconds, the Windows CE 5.0 desktop should appear.

Figure 6 - On/Off Switch

4. Flip the RFID module 180° as shown below. This will provide optimal tag

reading performance.

Figure 7 - RFID Module

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 111 112

Pas de commentaire

Rockwell-automation 57RF RFID ICODE Handheld Interface User Manual Manuel d'utilisateur Page 12