Rockwell-automation 2711P-Rxxxx Logic Module, Internal CompactFlash, a Manuel d'utilisateur télécharger pdf (Page 12)

12 Logic Module, Internal CompactFlash, and RAM

Publication 2711P-IN004J-EN-P - September 2009

Install a Logic Module

If the display module and logic module are ordered as separate components, attach the logic

module to the display module before panel installation.

1. Disconnect power from the terminal.

2. Set the display module of the terminal display-side down on a clean, flat, stable

surface to avoid scratches.

3. Position the logic module over the back of the display module until the two

connectors on the bottom of the logic module align with the connectors on the

display module.

4. Push down on the logic module until firmly seated.

5. Tighten the six captive screws that secure the logic module to the display module to a

torque of 0.58 N•m (5…7 lb•in).

Captive

Screw

Logic Module

Captive Screws

on Top and Bottom

1 2 ... 7 8 9 10 11 12 13 14 15 16

Commentaires sur ces manuels

Pas de commentaire