Rockwell-automation 2711P PanelView Plus Terminal User Manual Manuel d'utilisateur Page 151

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 246
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 150
Publication 2711P-UM001J-EN-P - November 2009 151
Install and Replace Components Chapter 6
Replace the Display
Module
This section shows how to replace the display module on 700 to 1500
terminals. It is necessary to remove the communication module from
the logic module to perform this operation.
Follow these steps to replace the display module.
1. Disconnect power from the terminal.
2. Remove the terminal from the panel.
3. Detach the communication module, if attached, from the logic
module by removing the four screws.
4. Loosen the six captive screws that attach the logic module to the
display module.
5. Carefully lift the logic module from the terminal.
6. Set the display module aside.
Communication Module
Display
Module
Logic Module
Logic Module
Captive screws
on top and bottom
Vue de la page 150
1 2 ... 146 147 148 149 150 151 152 153 154 155 156 ... 245 246

Commentaires sur ces manuels

Pas de commentaire