Rockwell-automation 2711E-NK5 Replacing the PanelView 1400E Keypad Fac Manuel d'utilisateur télécharger pdf (Page 3)

Replacing the PanelView 1400e Keypad Faceplate 3

To remove the keypad faceplate:

1. Place the terminal face down on a protective surface.

2. Use a Torx T-15 driver to remove the two small black screws

holding the cover plate on the left side of the keypad faceplate.

Save the screws and the plate.

3. The cable between the terminal and the keypad controller on the

faceplate is clipped to the terminal by a strain-relief clamp.

Release this by pressing down on the lower tab.

Step 2. Removing the

Keypad Faceplate

1 2 3 4 5 6 7 8 9 10 11

Pas de commentaire

Rockwell-automation 2711E-NK5 Replacing the PanelView 1400E Keypad Fac Manuel d'utilisateur Page 3