Rockwell-automation 2711C-xxxx PanelView Component HMI Terminals Insta Manuel d'utilisateur télécharger pdf (Page 12)

12 PanelView Component HMI Terminals

Publication 2711C-IN001H-EN-P - July 2014

These views show the panel clamps fully extended to secure the terminal against the rear

of the panel.

For a C600 (2711C-T6M, -T6C Series C or later, 2711C-T6T Series A or later only)

terminal, continue with steps 5 through 7.

2. Insert a mounting lever into each mounting slot on the terminal.

Slide each lever until the short, flat side of the lever touches the surface of the panel.

3. When both levers are in place, slide each lever an additional notch or two until you hear a click.

ATTENTION: Follow the instructions to provide a proper seal and to prevent potential

damage to the terminal. Allen-Bradley assumes no responsibility for water or chemical

damage to the terminal or other equipment within the enclosure because of improper

installation.

6

1

61

44872

44871

Fully extended panel clamps

61

61

Mounting slot

Short, flat side of mounting lever

44905

44906

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 35 36

Commentaires sur ces manuels

Pas de commentaire