Rockwell-automation 2098-UWCPRG Ultraware Software User Manual Manuel d'utilisateur télécharger pdf (Page 61)

Rockwell Automation Publication 2098-UM001G-EN-P - February 2011 63

Configuring the Ultra3000 Drive Chapter 3

The digital input's Preset Select Line binary values are as follows:

• Preset Select 0 = 1 if active, 0 if not.

• Preset Select 1 = 2 if active, 0 if not.

• Preset Select 2 = 4 if active, 0 if not.

If a Preset Select Line is not assigned to a digital input, the Preset Select Line is

considered inactive.

If you want to use only a single gear ratio, only set the Gear Ratio for Preset 0, and

do not assign the Preset Select 0, 1 or 2 to any digital inputs.

The Preset window has no associated status or direct commands. The Preset

window has these parameters:

TIP

Binary values for an active digital input's Preset Select Lines 3, 4 and 5 do

not apply to this calculation.

Parameter Description

Preset Velocities

Preset 0 through 7 The drive's preset velocity values.

Preset Velocity Input Limits

Accel/Decel Limits Indicates the state of the Acceleration and Deceleration Limits,

below, for the drive Preset Velocity, either:

• Active

• Inactive

Acceleration If Accel/Decel Limits is set to Active, this is the drive's

acceleration limit when:

• the drive is in Preset Velocity operation mode (as set in the

Ultra3000 Drive window) and

• changes in the Preset Select Line 0, 1 or 2 settings result in a

change to a higher Preset Velocity value.

This value has a range of 0 …2,147,483,647 counts per

second

Deceleration If Accel/Decel Limits is set to Active, this is the drive's

deceleration limit when:

• the drive is in Preset Velocity operation mode (as set in the

Basic Drive Setup window) and

• changes in the Preset Select Line 0, 1 or 2 settings result in a

change to a lower Preset Velocity value.

This value has a range of 0…2,147,483,647 counts per second

Preset Currents

Preset 0 through 7 The drive's preset current values.

1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 353 354

Pas de commentaire

Rockwell-automation 2098-UWCPRG Ultraware Software User Manual Manuel d'utilisateur Page 61