Rockwell-automation 1771-OMD AC(220V) Output Mod Installation Instruct Manuel d'utilisateur télécharger pdf (Page 5)

5AC (220V) Output Module Cat. No. 1771-OMD Series B

Publication 1771Ć5.26 - February 2000

     

Connections to the output module are made to the 21-terminal field

wiring arm (cat. no. 1771-WH) shipped with the module. Attach the

wiring arm to the pivot bar on the bottom of the I/O chassis. The

wiring arm pivots upward and connects with the module so you can

install or remove the module without disconnecting the wires.

You must supply ac (L1) at terminals A through D on the wiring

arm. You need four ac connections to accommodate the total

required surge rating on the module without overstressing any single

connection on the field wiring arm. Jumper all ac (L1) connections

together to prevent module damage.

1771-OMD/B Connection Diagram

Terminal A

Terminal B

Terminal C

Terminal D

Terminal E

220V ac

ac Low

Output 00

Output 01

Output 02

Output 03

Output 04

Output 05

Output 06

Output 07

Output 10

Output 11

Output 12

Output 13

Output 14

Output 15

Output 16

Output 17

Output

Device

(Actual wiring runs in this direction.)

11924ĆI

1 2 3 4 5 6 7 8 9 10 11 12

Pas de commentaire

Rockwell-automation 1771-OMD AC(220V) Output Mod Installation Instruct Manuel d'utilisateur Page 5