Rockwell-automation 1771-OAD AC(12-120V)Output Installation Instructio Manuel d'utilisateur télécharger pdf (Page 6)

AC (12-120V) Output Module6

Publication 1771ĆIN024B-EN-P - November 2002

ATTENTION

Do not put the module jumper in CSI mode when

you use this module in a complementary mode.

Your system will not operate properly.

To change the fuse blown jumper to the CSI mode:

1. Locate the fuse-blown jumper at the top-right edge of the module

circuit board, as shown.

STD

CSI

Fuse Blown Jumper

(shown in preset

STD position)

TopĆright edge of circuit board

12636ĆI

2. Use your finger to slide the jumper off the STD position (the

middle post and the left post).

3. Carefully reposition the jumper by sliding it onto the CSI position

(the middle post and the right post).

1 2 3 4 5 6 7 8 9 10 11 ... 15 16

Pas de commentaire

Rockwell-automation 1771-OAD AC(12-120V)Output Installation Instructio Manuel d'utilisateur Page 6